Philips STU801/05R - Manual (Page 6)

CONNECTIONS ■ To a TV only, using a coaxial cable
j
7.
8 .
10 .
11
.
Make the connections as shown in the drawing using the
coaxial cable supplied with your Receiver.
Connect your Receiver to the mains socket.
Switch your TV ON.
Switch the test picture switch on the back of your Receiver to
TEST.
Switch your TV to each of its programme numbers in turn to
check that^your Receiver is not causing interference with
terrestrial programmes.
If there is patterning, or any other interference on the screen,
adjust the TUNE control on the back of the Receiver until you
have a clear picture. Only a small adjustment, sufficient to
remove the patterning, should be made at a time.
Continue this procedure until you have checked all the
programme numbers on your TV.
Select a spare programme number on your TV which you will
always use for satellite programmes - this is now your ‘Satellite
Receiver number'. Tune your TV until you find a picture from
the Receiver.You will know that you are looking at a picture
from the Receiver when you see this picture appear on your TV
screen.
If the reception is poor, use a small screwdriver to turn the tune
control on the Receiver until the reception is clear. Go back to
Step 5.
Switch the test picture switch on the back of the Receiver back
to NORM.
Go to the section Connect Your Polariser or Aim your dish.
J
GB 4