Philips STU801/05R - Manual (Page 16)

PEaSONAUSING .PERSONALISING YOUR RECEIVER
Installation Menu
4
In this menu, you will find a number of general settings for your Receiver.
After you have adapted the vaiues to those fitting your instaliation and con­
nections, you normally do not have to enter this menu anymore.
O Press MENU foliowed by 2
D> The 9 light will be flashing and a menu iike the one shown will
appear on your screen.
If you decide not to modify anything or undo your modifications, press VIEW.
The MENU and O keys are used to move forward and backward through the
menu, and the are used to alter parameters. When you have
finished your modifications, press STORE to store your settings.
The foiiowing options are available:
1. CONTRAST
This is the picture contrast setting. Use the -<] or Q> keys to set the contrast
to LOW, MEDIUM or HIGH. Pressing the STORE key will retain any
adjustments made.
2. LNC 1 OFFSET
If the picture is speckly, it may be necessary to adjust the LNC offset. If you
still have menu 2 on your screen, press STORE (or VIEW).
O Press MENU followed by 1 on your remote control.
I> The 9 light on your Receiver will now be flashing.
Check that the frequency for the chosen programme is correct. (See the
Satellite Programme Guide in the back of this manual). If necessary, correct
the frequency using the <3 or O keys on your remote control.
Press STORE twice. o
o
o
o
o
o
Press MENU followed by 2.
Press MENU again to select LNC1 OFFSET
Use the <□ or [> key to get a picture as free from sparkles as
possible.
To optimise the picture, it is possible to change programmes
whilst in this menu by directly entering the programme number
using the numeric keys.
Press STORE to store your settings. The same procedure can
be followed for satellite input 2, after you have selected a
programme preset for this input.
3. LNC 1
Option 1 Allows you to assign any of 3 frequency bands to dish antenna
input 1. The bands are allocated as follows:
a. ASTRA (10950 -11700 MHz, Astra, Eutelsat, Intelsat)
b. . DBS (11700 - 12500 MHz, TDF, TVSAT, TELE-X, Olympus)
C. T-COM (12425 -12675 MHz, Telecom, Kopernikus)
Option 2 Allows you to assign any of 3 types of polariser in use to dish
antenna input 1. These 3 types are:
a. VOLT allows voltage switching to select the correct polarisation
(H for Horizontal, V for Vertical). This is the default setting for
dish input 1.
b. MECH permits either Mechanical or Electro-Magnetic polariser
capability.
C. BEIDE allows dual band LNC switching (e.g. Astra / DBS) in
addition to Mechanical or Electro-Magnetic polariser capability.
J
CONTRAST MED
LNC1 OFFSET 15
LNC1 ASTRA BAND
LHC 2 MECH
H-POL BASE 15
U-POL BASE 50
GB 14