Corinex Global Powerline Router - Manual (Page 38)

2.3 Step 3: Configuring the Router
In this Step, you will configure the Corinex Powerline Router to
communicate with the Internet through your Internet Service Provider
(ISP). For this you will need the setup information provided by your
ISP. If you do not have this information already, you have to contact your
ISP before proceeding.
This information from your ISP was used to configure your computer for
Internet access. Because you are now sharing Internet access between
several computers, you will use this setup information from your ISP to
configure the
Corinex Powerline Router instead of your computer.
Note: You only need to configure the Corinex Powerline Router only
once using the first computer you set up.
A. Open your web browser. (You can get an error message at this point.
Ignore it.) Enter http://192.168.1.1 in the web browser’s Address field.
Press the Enter key.
Fig.2.25 Http address field
35
Step 3: Configuring the Router
Corinex Powerline Router User Guide
http://192.168.1.1