Philips VHS VR6393 - Manual (Page 8)

Selecting the Display language
0 Press 4 to remove the cassette, if already loaded.
d) Press ►.
This will automatically switch on the video recorder.
The Display shows a language indication, for example ‘ENGL’,
‘DEUT.’, ‘FRAN.’ or ‘ITAL.’.
@ Press + or — to select the language indication of your
choice.
0 Press lO-
Tuning your TV to the video recorder signal
0
Switch on the TV.
© Press 4 to remove the cassette, if already loaded.
0 Press ►.
The Display shows, for example:
ii.i
0
Select on the TV the preselection (program) number for the
video recorder.
Most modern TVs have preselection numbers for selecting TV
stations or the video recorder signal.
Refer to the Operating Instructions of your TV to determine
which preselection number you must use and how to tune it.
® Tune the TV until you see the following black and white
pattern:
This should be around UHF channel 37.
If your TV has auto search tuning:
Store this channel on the chosen preselection number (see the
TV Operating Instructions).
0 If the reception of any TV station is of a poor picture quality
(disturbed picture), use a small screwdriver to turn the 30-39
channel control on the rear of the video recorder until the
reception is good. Then search again for the black and white
pattern, as described in steps and ©.
0 Press lO once you have finished tuning.
Note:
If you now want to play back a pre-recorded cassette, see the
chapter ‘Playing a cassette’.
REMOTE CONTROL
4
You can operate most of the functions of the video recorder
using the remote control unit.
Inserting the batteries
• Open the cover on the back of the remote control.
• Insert the batteries as indicated in the battery holder.
If you want to control video recorder functions:
• Set (TV/VCR) to position ‘VCR’.
• Aim the remote control at the video recorder and press the
required button.
If you want to control TV functions:
• Set (TV/VCR) to the position ‘TV’.
• Aim the remote control at the TV and press the required TV
function button (e.g. digit buttons (0-9) to select TV stations).
To select numbers:
Using -I- or — you can change:
— preselection numbers
— channel numbers
— a time indication.
However, instead of using + or —, you can also use the digit
buttons (0-9) on the remote control.
For numbers 0-9:
• Press the required digit button.
For numbers 10-99:
• Press (-/-) until the Display on the video recorder shows
• Press the required digit buttons.
For number 100-120 (only for channel numbers):
• Press (-/—) until the Display of the video recorder shows ‘—’.
•
Press the required digit buttons.
To return to single digit entry press (-/--) again until the Display
shows
4 ( g ^