Philips VHS VR6393 - Manual (Page 10)

© Press STORE.
® Repeat steps © to © for all the TV stations.
General notes:
— After you have stored all TV stations, you can use + or —
or the digit buttons (0-9) to select these TV stations.
— If you store a TV station on a number that has already been
used, the new station will be stored, and the old TV station will
be deleted.
DIRECT RECORDING
6
Have you followed the instructions in the chapters ‘Installation’
and ‘Storing TV stations’?
If so, proceed with this chapter.
You do not need to switch on the TV. However, if it is on, you can
change to another TV station on your TV without interfering with
the TV programme being recorded.
If you want to watch the TV programme to be recorded, switch
on the TV and select the preselection number for the video
recorder.
Checking or changing the tape length indication
• Press (сто) on the remote control.
A tape length indication (e.g. E30 = 30 minutes - E300 = 300
minutes) is shown on the LCD Display of the remote control.
CASSBTTE
\ \ t i 1 f
- TRANSMIT-
r n i i n
O l . i u
■ ' I t 1 » \
If the tape length shown is not the same as the tape length of the
cassette to be loaded:
• Press -I- or — on the remote control to change the tape
length in the following sequence: E30, E60, E90, E105, E120,
E150, E180, E195, E210, E240, E300, EC30, E30, ect.
• Press ((((O) on the remote control.
If the transmission is accepted the Display of the video recorder
shows, for example:
Tone
Ml) )_
c o u n
!_!_ l U
Notes:
— The used time or time left display will only be correct if you
have selected a tape length which is the same as the actual
length of the cassette to be loaded.
— After you have selected the tape length, or you have loaded
a new cassette, the used time and time left display initially
shows:
Then after a few seconds of tape movement the
correct times are shown on the display.
Loading a cassette and recording
© Hold the cassette with the title label facing you and the
window side up.
Push the cassette at the centre until it is pulled inside
automatically.
Inserting a cassette will switch on the video recorder
automatically.
Do not try to pull out the cassette during automatic loading.
© If necessary, press ►► or 44 to (re)wind the tape.
If you want to switch between the used time
(u),
the time
left (L)or the tape counter during the (re)windlng, recording or
playback:
• Press (l®D one or more times.
Depending on the cassette used, the actual recording time can
be about 5 minutes longer (for example 3:05 Instead of 3:00
hours with a E180 tape).
Note:
Pressing X resets the tape counter to ‘O’.
© Use -f or — or the digit buttons on the remote control to
select the TV station you want to record from.
© Press • (or the two buttons A with • on the remote control
simultaneously) when the TV programme starts.
The Display shows, for example:
Q C r
11 !_ )_
p 3
Sia •
О o n
L . U U
The TV programme is now being recorded.
Notes:
— During a recording it is impossible to select another TV
station.
— If a cassette is not loaded in the video recorder when you
are trying to make a recording, the Display shows for example:
f ~ O C О
L . I l_l_l P C
г I O T I
»_ IL.IL.I
6 (Gg)