Interlogix XL 4 Zone LCD - Manual (Page 9)

8 Zone Keypad
Operation 2 Zone Keypad
Operation
22-9050 v1.3 MONITOR ISM™/AFx™ Multi-Tenant Security System User Guide 7
2 3
5 6
8 9
0
1 2 3 4 5 6 7 8
S T
f
4
7
1
X
!
Special Command If you had a special command arranged to activate a special function. Check with
your Security Dept.
Press then
for Special Command #1
Press then
for Special Command #2
Repeat the same
sequence to turn
the command off. Press then once to turn feature on.
Repeat to turn off.
NOTE: If it is necessary for you to add your PIN
when doing system arming procedures (example:
system ON or in STAY), you will need to add it with
these commands too. F and 1 and PIN or F and 2
and PIN.
NOTE: If it is necessary for you to add your PIN
when doing system arming procedures (example:
system ON or in STAY), you will need to add it with
this command too.
and 5 and PIN.
Change your PIN number
Press then then enter old PIN,
then enter new PIN and enter the same new PIN
again to confirm it.
Press then then enter old PIN,
then enter new PIN and enter the same new PIN
again to confirm it.
Adding a New User
Groups of users 2-8 for each suite must be set as “unassigned” by Building Security Administration before
user’s can be added (assigned) at a keypad. A new suite will have a Master User # 1 temporary PIN. Ask
your Security Representative what the PIN is and change it later.
Press and then press Press and then press
Then for either keypad:
• Enter your Master user PIN.
•
Now enter the new user’s identification number. (There can be 8 users in the system, 1 – 8. If you know
you are Master user # 1 then that user ID position is not vacant. Press the next user ID # “2” for the new
user. That position will now be occupied. The next new user would get ID # 3 and so on until all 8 ID
positions are eventually occupied.)
• Now enter the new user’s Authority #. The new user can be assigned with one of the following Authority
Levels, limiting their abilities as required:
Authority Levels
Turn
System
ON
Turn
System
OFF
Turn
to
STAY
Bypass
Zones
Remove
Bypass
Test
System
Edit
Users
Reset
Alarms
Special
Command
On / Off
MASTER enter “2”
√ √ √ √ √ √ √ √ √
Resident enter “3”
√ √ √ √ √ √ √ √
Guest enter “4”
√ √ √
Cleaner enter “5”
√
5
2
1
9
9
0