Interlogix XL 4 Zone LCD User Manual
Page 8
8 Zone Keypad
Operation
2 Zone Keypad
Operation
6
MONITOR ISM™/AFx™ Multi-Tenant Security System User Guide
22-9050 v1.3
2
3
5
6
8
9
0
1
2
3
4
5
6
7
8
S
T
f
4
7
1
X
!
Turning the System On Remotely If you left and forgot to turn the system on, it can be remotely armed
by the building security dept. Contact the guard, identify your suite and ask the guard to turn the system
on.
Verify User If you think you have caused a false alarm (keypad tones continuously) you can notify the
Security Dept. that YOU are on the premises before contacting them by phone.
If armed, turn system off with PIN #.
Then, send Verify Code:
Press
then
and your PIN again.
If armed, turn system off with PIN #.
Then, send Verify Code:
Press
then
and your PIN again.
Bypass a Sensor Zone
NOTE: An entry/exit sensor zone, example: main entrance door cannot be bypassed.
Press
then
then the
Sensor Zone number 1 – 8 and your PIN.
Only one point can be bypassed at a time. Repeat
the same sequence to remove the zone’s bypass.
A Master or Resident authority level User turning
the system OFF will automatically remove a
bypass.
Press
then
then the
Sensor Zone number 1 or 2 and your PIN.
Only one point can be bypassed at a time. Repeat
the same sequence to remove the zone’s bypass.
A Master or Resident authority level User turning
the system OFF will automatically remove a
bypass.
Chime
Keypad warning tone that entry door has been opened.
Press
then
turns chime on.
Press
then
turns chime off.
Press
then
once to turn
feature on.
Repeat to turn off.
System Test
All keypad lights, sounder turn on for 5 seconds.
Press then then
PIN.
Press
to stop sooner.
Press then then then
PIN.
Press
to stop sooner.
Walk Test
Protection points can be tested with this command. After entering the command at the keypad,
trip the protection points. Example: open front door and close it, the light marked 1 turns on solid. This
means protection point # 1 is working OK. Do the same to test the next point, example: light marked # 2 is
a motion detector. Trip it and let it reset. Light # 2 turns on solid, etc.
Press then then
PIN.
Test will last 5 minutes or press
to stop.
Press then then then
PIN.
Test will last 5 minutes or press
to stop.
4
X
#
6
7
!
8
4
8
6
5
7
2
7
1
X
#