Welcome new users, Multi-tenant security system user guide – Interlogix XL 4 Zone LCD User Manual

Page 3

Multi-Tenant Security System User Guide

22-9050 V1.3 (4.2004) MONITOR ISM™/AFx™ Multi-Tenant Security System User Guide

Welcome New Users!

There are two types of suite security keypads. Follow the instructions in the proceeding columns under
the picture of the keypad that you have.

But first…

Be sure to ask your Security Representative –

•

What your temporary PIN (Personal Identification Number) is to operate your keypad and

the system?

Each suite is set up with a single Master User # 1 PIN like 1-2-3-4 to get you started and be

able to access all the features. Later, you will read in this guide how to change it yourself to a
personal one.

•

If you will need to use your PIN all the time?

“Quick

Arm” This feature allows you to enter certain commands at a keypad like turning the system

ON and not always have to enter your PIN too.

“Secure Arm” The system has been set up so that you will need to enter your PIN for any function /

command.

•

How long you have to go out or come in?

When you turn protection on normally, you will have a delay to go out the front door without causing an

alarm and your keypad will beep while you are leaving. The same for when you open the door to come
in again and turn the protection off.

Find out how long these delays are to leave or come in before they end and you cause a false alarm.

Contents

System Quick Reference Guide.................................................................................................................. 2

The Suite Security Keypads, An Overview.................................................................................................. 3

Operation .................................................................................................................................................... 4

To do a “SEND HELP” Alert (to Building Security) ................................................................................. 4

If an error is made when making key presses at a keypad..................................................................... 4

Turning system OFF or Silencing an ALARM condition (keypad tones continuously)............................ 4

Turning ON (leaving) .............................................................................................................................. 4

Turning to STAY remain inside the protected area ................................................................................ 5

Turning the System On Remotely ......................................................................................................... 6

Verify User (If you think you have caused a false alarm) ....................................................................... 6

Bypass a Sensor Zone ........................................................................................................................... 6

Chime (Keypad warning tone that entry door has been opened.) .......................................................... 6

System Test (All keypad lights, sounder turn on for 5 seconds.)............................................................ 6

Walk Test (Protection points can be tested with this command) ............................................................ 6

Special Command (Activate a special function.) .................................................................................... 7

Change your PIN number....................................................................................................................... 7

Adding a New User ................................................................................................................................ 7

Erasing an Existing User ........................................................................................................................ 8

Additional Commands for the 8 Zone Keypad Only .................................................................................... 9

Identifying a user’s ID number................................................................................................................ 9

Grant Lobby Access ............................................................................................................................... 9

8 and 2 Zone Keypad Light Descriptions .................................................................................................... 9

8 and 2 Zone Keypad Tone Descriptions.................................................................................................. 10

8 and 2 zone Suite Security modules are not intended for Life/Safety applications.

∗