Interlogix XL 4 Zone LCD - Manual (Page 11)

Multi-Tenant Security System User Guide
22-9050 v1.3 MONITOR ISM™/AFx™ Multi-Tenant Security System User Guide 9
Additional Commands for the 8 Zone Keypad Only
Identifying a user’s ID number
After this command is entered, the user’s ID # (2-8, the master user usually being 1) will display on the 8
sensor zone lights. Example, if user’s PIN entered belongs to the 5
th user, sensor zone light # 5 will turn
on. This feature identifies for the master user which user locations are vacant or can have their user PIN
erased, in order to add new users.
Press
then then a Master PIN, then the User’s PIN whose user number you
want to check, 2 – 8.
The Ready, Armed and Trouble lights will flash and the user’s # light is on steady.
The indication will last 10 seconds or press
to reset the keypad back to normal operation.
Grant Lobby Access
If pre-arranged with Security Management, this command can send a signal to the building security main
desk, concierge, to authorize a visitor’s entrance.
Press
then then a Master PIN.
8 and 2 Zone Keypad Light Descriptions
Light Display Meanings
Trouble Triangle
Slow Flash
Fast Flash
On
On
− System hydro mains power failure
− Communication problem with building main control
equipment.
− Possibly keypad base lose causing tamper alert.
(8 Zone Keypad only)
−
With fast flashing Sensor Zone(s), either keypad.
−
Sensor zone wiring faulty.
− Incorrect sensor zone programming.
– Check with your Security Representative.
System Okay
On
Off − Sensor Zones okay. System ready to arm.
−
Sensor zone(s) insecure or system is ON.
Armed
Off
On
Flashing
− Protection off.
− Protection in STAY (remaining inside, no internal motion
detectors on, only doors and windows protected).
−
Protection Fully ON
Sensor Zones
1 – 8 (8 Zone Keypad)
1 and 2 (2 Zone)
Off
On
Slow Flash
Fast Flash
− OK or protection ON.
− Insecure or system in Walk Test.
− Bypassed.
− With Trouble light. Example: wiring fault.
1 2
X
3
S
T
0
2 3
5 6
8 9
0
1 2 3 4 5 6 7 8
S T
f
4
7
1
X
!