Interlogix TruVision 360° Configuration Manual User Manual
Page 16
14
TruVision 360° Camera Configuration Manual
Parameters
Description
2.
Port
HTTP Port: Specifies the port used for the Internet Explorer (IE)
browser. Default value is 80.
RTSP Port: Specifies the RTSP port. The default port number is 554.
HTTPS Port:
Specifies the HTTPS port. The default port number is 443.
Server Port: Specifies the SDK port. The default port number is 8000.
3.
DDNS
Specifies the IP server, DynDNS and ezDDNS.
4.
PPPoE
Use this option to retrieve a dynamic IP address.
5.
SNMP
Enable SNMP to get camera status and parameters related
information.
6.
802.1.X
When the feature is enabled, the camera data is secured and user
authentication is needed when connecting the camera to the network.
7.
QoS
Enable to solve the network delay and network congestion by
configuring the priority of data sending.
8.
FTP
Specifies the FTP address and folder to which snapshots of the
camera can be uploaded.
9.
UPnP
Enable and set the friendly name detected.
10.
Specifies the email address to which messages are sent when an
alarm occurs.
11.
NAT
Specifies port mapping mode.
To define the TCP/IP parameters:
1. Click
Configuration
>
Network > TCP/IP
.
2. Configure the NIC settings, including the NIC Type, IPv4 settings, IPv6 settings,
MTU settings, and Multicast Address.
3. If the DHCP server is available, check
DHCP
.
4. If the DNS server settings are required for some applications (e.g., sending email),
you should configure the
Preferred DNS Server or Alternate DNS Server
.
5. Click
Save
to save changes.
To define the port parameters:
1. Click
Configuration
>
Network > Port
.
2. Set the HTTP port, RTSP port, HTTPS port and Server port of the camera.
HTTP Port: The default port number is 80, and it can be changed to any port No.
which is not occupied.
RTSP Port: The default port number is 554. It can be changed to any port number
in the range from 1 to 65535.
HTTPS Port: The default port number is 443. It can be changed to any port number
that is not occupied.
Server Port: The default server port number is 8000. It can be changed to any port
number in the range from 2000 to 65535.