Interlogix NX-8V2 REV H Installation Manual - Manual (Page 69)

Appendix A: Reporting codes
NX-8V2 Control Panel Installation Manual 65
Device Name Number
570E/580E
Switch 3 on Device address 25
Switch 1 and 3 on Device address 26
Switch 2 and 3 on Device address 27
Switch 1, 2, and 3 on Device address 28
All switches off Device address 29
Switch 1 on Device address 30
Switch 2 on Device address 31
Table 16: Keypad numbers for reporting trouble conditions
Keypad
number Partition
1 2 3 4 5 6 7 8
1 192 193 194 195 196 197 198 199
2 200 201 202 203 204 205 206 207
3 208 209 210 211 212 213 214 215
4 216 217 218 219 220 221 222 223
5 224 225 226 227 228 229 230 231
6 232 233 234 235 236 237 238 239
7 240 241 242 243 244 245 246 247
8 248 249 250 251 252 253 254 255
Zone ID or user ID hex digit for 4+2 formats
Zone or user ID hex digits only apply to slow formats (Locations 56 to 83, lower
digit). The digits programmed in these locations are sent as the upper hex digit in
place of the alarm event code. The zone ID or user ID are always reported as the
lower hex digits. The following table shows the hex digit for the zone/user IDs.
For example, if the zone/user ID is 15, the 4+2 lower digit is F.
Table 17: Zone/user ID and hex digit
Zone/user ID = Hex digit Zone/user ID = Hex digit Zone/ID = Hex digit
1 = 1 2 = 2 3 = 3
4 = 4 5 = 5 6 = 6
7 = 7 8 = 8 9 = 9