Interlogix NX-8V2 REV H Installation Manual - Manual (Page 32)

Chapter 2: Reporting codes
28 NX-8V2 Control Panel Installation Manual
Segment 1
1. On enables two call answering machine defeat.
2. On enables tone sniff answering machine defeat.
3. On requires call back before download session.
4. Shutdown. (Can only be activated with the download software).
5. On locks all local programming. (Can only be activated with the download software.)
6. On locks programming of all locations associated with the communicator. (Can only be
activated with the download software.)
7. On locks out download session. If on, locations 19 to 22 c annot be viewed from the keypad.
They can only be viewed from the keypad when off. (Can only be activated with the download
software.)
8. On enables call back at autotest interval.
Location 22 - Download call back number
Location 22 has 20 segments of numerical data. Use this location to enable the
control panel to hang up for approximately 36 seconds (ensuring that the calling
party has disconnected) before calling back. For the control panel to perform this
operation, you need to program a telephone number into this location and you
need to enable option 3 (require callback) in Location 21. Each segment default
is 14.
• To program a delay of 4 seconds, enter 13 in the appropriate segment.
• To program tone dialing, enter 15 in the segment where tone dialing begins.
• If the entire number is tone dialing, enter 15 in the first segment.
• Enter 11 for a *, and 12 for a #.
• Enter 14 to indicate the end of the phone number.
Caution: Verify that the callback phone number is accurate before
disconnecting.
Locations 23 and 24 - Partition features
Location 23 - Feature report selection/partition feature selection
Location 23 has five segments of feature selection data. Use this location to
enable certain features that are accessed or visible to the user from the system
keypad. In addition, you can enable certain communicator reports in this location.
(Defaults are shown in bold.)