Interlogix NX-4V2 Installation Guide - Manual (Page 8)

protected area, is acceptable, provided it is rated for outsid
service and alarm conditions are transmitted to:
a) The dispatch location of the law enforcement agency having
jurisdiction over the protected property or
b) A central station or residential monitoring station complyin
with the Standard for Central-Station Alarm
e
g
Services, UL 827.
rotection, or outside
ing
t
n
as to minimize access by an intruder.
In a mercantile burglar alarm system, an alarm sounding
device located within the area of greatest p
the area of greatest protection but within an area protected by
an alarm system and that shares a common control unit with
the system installed in the area of greatest protection, is
acceptable provided it is rated for inside service and alarm
conditions are transmitted to:
a) The dispatch location of the law enforcement agency having
jurisdiction over the protected property or
b) A central station or residential monitoring station comply
with the Standard for Central-Station Alarm Services, UL 827.
An inside sounding device shall be mounted at least 10 fee
(3.05 m) above the floor or at the surface of the ceiling. Whe
there is fixed construction within the area that could provide
access for an intruder, the alarm sounding device shall also be
mounted at least 4 feet (1.2 m), as measured horizontally away
from the edges of the fixed construction or at least 10 feet
(3.05 m) above it so
WARNING: Electrical codes will vary, depending upon the
country and city where the system is installed. It is the
installer’s responsibility to ensure that the electrical installation
is safe and conforms to all applicable codes, laws, or
evice regulations. Only qualified persons should connect this d
to the main supply.
M m configurations for UL installations
following requirements ap
in
The ply to residential fire, residential
rg
•
be
pplied screws to be used.
or residential
applications.
abled for all commercial burglary
UL requires th m panel ount of
failure. T below lists the battery
ee meet time limits based on the current
draw of the pa ll atta vices.
Table 6: Batter
Standby time Total Standby battery
ty
Alarm current
imum syste
bu lary, and commercial burglary installations.
The NetworX NX-4V2 panel is necessary • to initiate
residential and commercial installations.
At least one compatible keypad is needed for all
applications.
• The AD10-12 bell and UL Approved bell-housing shall
used for all applications.
• Commercial UL applications require the NX-003-C metal
enclosure. Su
• A minimum of two keypads is required for home health
applications, and each keypad must be set to a unique
address.
• The wireless devices are only UL listed f
• The DACT shall be en
applications.
at an alar work for a minimum am
time during a p
capacities n
ower
ded to
nel and a
able 6
ched de
y capacities
auxiliary
current capaci
24-hours 1.9 A
600 mA
51 Ah
17 Ah
600 mA
1 A
1.25 A 34 Ah 1 A
48-hours 900 mA
600 mA
300 mA
51 Ah
34 Ah
17 Ah 1 A
1 A
1 A
72-hours 600 mA
400 mA
200 mA
51 Ah
34 Ah
17 Ah 1 A
1 A
1A
Note: Calculations are based on three 17 A batteries.
WARNING: Replace only with a Panasonic LC12V4BP or
Yuasa NP$-12 battery. There is a risk of explosion if the
power
removing all power from the unit.
battery is replaced with an incorrect type.
If separate power supplies are necessary to accommodate
additional devices, safety standards require that each
supply be prominently marked with adequate instructions for
Caution: Observe pol y when installing a new battery. arit
Installing th
panel. Disp
e battery b age to the
ose of used g to the
structi ns and/or local government authorities.
ackwards may cause dam
batteries in accordin
manufacturers in o
Specifications
Operating power 16.5 VAC 40 or 50 VA transformer
Auxiliary power
w/25 VA
transformer
w/4
transforme 0 or 50 VA
r
or US
2 VDC regulated 500 mA
(MG Electronics part
number 22-156 f
or 22-156-CN for
Canadian installations)
1
12 VDC regulated 1 A
Loop resistance
Standard loop 300 ohms maximum
Fuse Type T 200 mA 250 VAC
Built in siren driver Two tone (temporal and yelp)
8 NX-4V2 Control Panel Installation Instructions