Interlogix NX-4V2 Installation Guide - Manual (Page 7)

UL365 Police station connected burglar alarms
UL609, CAN/ULC-S303- Mercantile, police station connect with
-C M91 basic line security requires NX-003
enclosure
UL985, CAN
M89 /ULC-S545- Household fire
UL1023, ORD-C1023-
1974 Household burglary
UL1610 Central station burglar alarm unit
UL16 ystem units 35 Digital alarm communicator s
UL1637 Home health care signaling
Whe nderwriters
observed:
•
•
4T-12 or equivalent.
• ed. The auxiliary outputs
utes for commercial burglary, four minutes
al
test
l burglary
•
ted.
• assing must be disabled.
•
R
n UL listed
tions.
• nabled.
0 seconds.
• ttery, limit
• ery,
•
• ted
0,12,13,14; Silent Knight 9000 - 2,12; FBI -
and 13.
0 percent in the area of coverage, and similar
, and so
• ate the siren.
, the
e
-1215W,
,
sensor: S1224MC strobe series;
2
wire detectors): ESL: 500N
series; 449CTE series; 521 series; 541 series
4TR;
ises or area of
the building in which the alarm system is installed or
e service
antile alarm
n installing an NX-4V2 in compliance with U
Laboratories, the following instructions must be
• Initiating and indicating devices must be rated at 11.5 to
12.4 VDC residential, 12.0 VDC commercial.
Force arming and auto arming must not be enabled.
For residential fire applications, the indicating devices
shall be a Wheelock 3
• The listen in feature shall not be enabled.
The siren/bell test must be enabl
controlling the audible device require a minimum cutoff
time of 15 min
for residential applications, or 30 minutes for commerci
burglary for Canada.
• For residential fire installations, the dynamic battery
time cannot exceed four hours.
• Ringback must be enabled on UL commercia
installations.
On commercial burglary installations, the fire initiating
circuits must not be connec
• The entry guard feature must be disabled.
Group byp
• Delay before dial seizure must be set to 0.
Total current draw from auxiliary power connections at
terminal positions POS, AUX PWR, and SMOKE PW
must not exceed 400 mA.
• Remote downloading must not be used o
systems.
• For residential burglary applications, the maximum entry
and exit delay times are 45 and 60 seconds respectively.
The exit delay time must not exceed 60 seconds for
commercial burglar alarm applica
• The keyswitch option must not be used.
The telephone line monitor must be e
• The telephone line cut delay must not exceed 9
• The 24-hour communicator test transmission is required.
For 24-hours of standby power using a 7.0 Ah ba
auxiliary power load to 140 mA.
For 24-hours of standby power using a 17.2 Ah batt
limit auxiliary power load to 400 mA.
The silent keypad option must not be enabled.
UL has only verified compatibility with the following lis
DACRs and formats: Sure-Gard SG-MLR2-DG:
2,9,1
CP220FBI, 13; and Ademco 685: 2,11,12,
• For burglary installations, cross zoned detectors must
overlap 10
coverage areas must be used. For example, interior
protection is cross zoned with interior protection
on.
Expander trouble must activ
• For UL 1637, expander trouble must activate the keypad
sounder.
• If the late to close/early to open feature is enabled
op ning and closing reports must be enabled.
• For Canadian installations, the class II transformer secure
tab must not be employed.
e • Th four-wire smoke detector employed must be rated to
operate over the voltage range of 11.5 to 12.4 V.
• Compatible listed devices: (special applications):
• Bell output (sirens): Wheelock models: NS
NS-121575W, NS4-1215W, NS4-121575W, AS-1215W
AS-121575W
• Horn/strobe system
12 4MC Horn/strobe series; H12/24 Horn series
• Smoke output (four-
• System sensor models: 2112/24R; 2112/2
2112/24AT; 2112/ATR; 2112/24AITR; 4WTA-B; 4WTR-B;
4WTAR-B; 4WITAR-B
• Detection systems: F220-B6C; D273 series; Hochiki:
SBC-4/12, 4/12W
Additional UL 609 installation requirements
The alarm housing for a mercantile alarm system without a
remote alarm transmission connection shall be mounted on the
outside of the building, visible from a public street or highway.
It shall be accessible for examination and repair. It shall also
be located not more than four stories above the street level
unless:
a) A second alarm sounding device and housing, intended for
outside service is mounted adjacent to the prem
b) A second alarm sounding device, intended for insid
is mounted within the premises.
In either case, the outside alarm sounding device and housing
may be mounted as high as the seventh floor.
Additional UL 365 installation requirements
In a mercantile burglar alarm system, a merc
sounding device located within a building, but outside the
NX-4V2 Control Panel Installation Instructions 7