Cabletron Systems Environmental Module TM 9C300-1 - Manual (Page 33)

3-21
Interactive Mode
The Module Backplane Screen
Select on the Module Specific Screen, as shown in Figure 3-24, to
access the Module Backplane Screen, as shown in Figure 3-27. The Module
Backplane Screen displays the current MMAC-Plus backplane configuration for a
selected module.
Line 1 identifies the selected module by chassis slot location.
Line 2 displays the module’s FNB connection (if applicable) and connection
status. Refer to the MMAC-Plus Operation Guide for further information about
FNB configuration.
Line 3 displays the module’s INB connection (if applicable) and connection status.
Refer to the MMAC-Plus Operation Guide for further information about the
INB.
Figure 3-27. The Module Backplane Screen
Select to return to the Module Specific Screen.
The Environmental Module Specific Screen
Select on the Module Selection Screen, as shown in Figure 3-23, to access
the Environmental Module Specific Screen, as shown in Figure 3-28.
Line 1 displays the Environmental Module’s current status (on-line or fault) and
the hardware revision.
Line 2 displays the Environmental Module’s firmware and boot prom revision.
Line 3 displays the Environmental Module serial number.
Figure 3-28. The Environmental Module Specific Screen
Select to access the Environmental Module Environment Screen (used to
view Environmental Module electrical and environmental parameters).
Select to return the display to the Module Selection Screen.
MODULE xx
INB A B/W ALLOC xxx MBPS
FDDI 1 INS PRI FDDI 2 BYP
EM STATUS ON-LINE HW REV xxx
SN xxxxxxxxxxxx
FW REV x.xx.xx BOOT PROM REV x.xx.xx