Cabletron Systems Environmental Module TM 9C300-1 - Manual (Page 30)

9C300-1 Environmental Module Operation
3-18
The BBU Screen
Select from the System Screen, as shown in Figure 3-15, to view the status
of the Battery Backup Units (BBUs). Figure 3-22 shows the BBU Screen.
Line 1 displays the screen heading.
Line 2 displays BBU status (CHARGING, STANDBY or DISCHARGING) if BBUs
are installed; however, if no BBUs are installed, the message NO BBU
INSTALLED displays.
Line 3 displays the estimated amount of system run time stored in the BBUs if the
system is running on a standard power source; or, if the system is running on
BBUs, the amount of system run time remaining in the BBUs at the current power
load.
Figure 3-22. The BBU Screen
Select to return to the System Screen.
The Module Selection Screen
Select from the Main Screen, as shown in Figure 3-13, to display
the chassis slot locations in which modules have been installed.
Line 1, as shown in Figure 3-23, displays the screen heading.
Lines 2 and 3 list all modules in the MMAC-Plus by slot number.
Figure 3-23. The Module Selection Screen
Select to return to the main System Screen.
BBU CHARGING
BATTERY STATUS
SYSTEM RUN TIME AT PWR LOSS xxx MINUTES
<1> <2> <3> <4> <5> <6> <7>
MODULE SELECTION
<8> <9> <10> <11> <12> <13> <14>