ILY SATA Blu-ray/DVD/CD Duplicator Controller User Manual
Page 18
Allows the copying of the CD-TEXT on the
(5)
Copy CD-TEXT:
master disc(s) to the target disc(s).
Press
ENT
or
to select mode and
press ENT to confirm
(6)
Copy UPC/ISRC: Allows the copying of the UPC/ISRC on the master disc(s) to the target disc(s).
Press
ENT
or
to select mode and
press ENT to confirm
(7)
Copy CD+G: Allows the copying of CD+G files on the master disc(s) to the target disc(s).
Press
ENT
or
to select mode and
press ENT to confirm
(8)
Auto Erase: Allows the erasing of files on the rewriteable CD’s or DVD’s
(9)
Image Fail: When image file fails to load into HDD, that file can be deleted from HDD.
Press
ENT
or
to select mode and
press ENT to confirm
12.
HDD Manager – This command is for the management of the hard disk drive (HDD) installed in the
duplicator.
Note: This feature is only available on duplicators with a HDD installed. If there is no HDD present in the duplicator,
this feature will NOT show in the menu of commands.
1.)
Select Image: Allows the selection of the image(s) present on the HDD. The Scroll buttons cycle
through the image(s) on the HDD and the ENT button confirms the selection while the ESC button
cancels the selection. The image(s) are listed in order of which they were loaded.
Press
ENT
or
to select image and
press ENT to confirm
16
2.)
Disc => Image: Transfers the information from the master CD/DVD/BD to the HDD. After the
image(s) transfer is complete, the reader drive is ejected and the source drive is changed to
the HDD.
Press
ENT
The source disc loaded to
HDD as image file, A001.
Use or to select the character desired.
Press ENT to go to the next position.
There are a total of 6 positions for the password. To enable the password, set all 6 positions.
For space, press ENT without choosing a character to leave the position empty.
Press ESC to cancel the process.
The duplicator will ask for password when “11. Setup” is selected
If Disable is selected, no password will be set and the display will direct back to the
Setup sub-menu.
If Enable is selected, a password must be entered using the following guidelines: