ILY SATA Blu-ray/DVD/CD Duplicator Controller User Manual

Page 11

Set Burn Speed – This feature allows you to set the burn speed of various types of disc: CDs (data and

VCDs), audio CDs, DVDs, dual-layer DVDs (DVD DL), and Blu-ray (BD-R SL, BD-R DL, BD-RE SL, and

BD-RE DL).

Selectable burn speeds:

CD: 1, 2, 4, 8, 10, 12, 16, 20, 24, 32, 36, 40 (default), 44, 48, 52, 56, MAX.

Audio CD: 1, 2, 4, 8, 10, 12, 16, 20, 24 (default), 32, 36, 40, 44, 48, 52, 56, MAX.

DVD: 1, 2, 2.4, 4, 6, 8, 12, 16 (default), 18, 20, MAX.

DVD DL: 1, 2 (default), 2.4, 4, 6, 8, 12, 16, 18, 20, MAX.

Blu-ray: 1, 2, 4, 6, 8, MAX.

To Set the Burn Speed:

1. Power on the machine (if not already on)

2. Use the Scroll buttons to select “7. Set Burn Speed”. Press the ENT button.

3. The first speed selection is for general CDs. Use the Scroll buttons to select the desired burn speed

and press the ENT button.

4. The second speed selection is for audio CDs. Use the Scroll buttons to select the desired burn speed

and press the ENT button.

5. The third speed selection is for DVDs. Use the Scroll buttons to select the desired burn speed and

press the ENT button.

Note: The selection is only available on DVD duplicators.

6. The fourth speed selection is for DVD DL. Use the Scroll buttons to select the desired burn speed and

press the ENT button.

Note: The selection is only available on DVD duplicators.

7. The last speed selection is for Blu-ray. Use the Scroll buttons to select the desired burn speed and

press the ENT button.

Note: The selection is only available on Blu-ray duplicators.

Press ENT &

and press ENT to set

general data CD burning speed

or and press ENT to set audio CD burning speed

and press ENT to

set DVD burning speed

and press ENT to

set DVD DL burning speed

and press ENT to

set BD burning speed

Finish and return

to main menu

Source Select – This command will allow you to change the source drive to any one of the drive(s)

inside the unit, including the HDD (if installed).

To change the source drive inside the unit to a different drive:

1. Power on the machine (if not already on).
2. Use the Scroll buttons to select the “8. Select Source: Press the ENT button.
3. The current Source Drive will be displayed along with the partial model number of the drive

and the port number in brackets.

4. Use the Scroll buttons to select from other available drives until the port number of the desired

drive is displayed.

5. Press the ENT button. The desired drive will then become the Source Drive.

Press ENT

Display current Source

Drive setting