ILY SATA Blu-ray/DVD/CD Duplicator Controller - Manual (Page 15)

11. Setup – This command contains options to configure the duplicator system.
1.) Start-up Menu: Sets the command to be displayed first when the machine is powered up and
initialized. All primary commands are available to be set for Start-up: Copy, Test, Copy & Verify,
Copy & Compare, etc.
Press
ENT
or to select function and
press ENT to confirm
2.) Auto Start: Set the amount of time before the duplicator will automatically start the selected
command ranging from OFF (no auto start) to 99 seconds in 1-second increments (1, 2, 3….97,
98, 99).
Press
ENT
or to select seconds and
press ENT to confirm
3.) Display Mode: Changes the display readout during the performance of various commands.
The “Basic” mode displays a progress bar, along with the amount of total data in MB on the master
DVD (or in time for the master CD). The “Expert” mode displayed the percentage of the process
completed, the amount of data transferred and the total amount of data on the master disc.
Press
ENT
or to select mode and
press ENT to confirm
4.) Beep: Turns the audio signal (a beeping sound) ON or OFF for pressing of the buttons.
Press
ENT
13
or to select mode and
press ENT to confirm
5.) Power on Eject: Allows the drive(s) with disc(s) present inside to eject the disc trays when the
machine is done initializing.
Press
ENT
or to select Eject All/ No
Eject/ Eject Target/ Eject Source
and press ENT to confirm