Actual direction control, Adjustment mode, Auto return – Heli-Max HMXE0832 User Manual
Page 12

12
To return to the normal fl ight mode, press the “F Mode” button again. The
rear LED will fl ash twice, stay on for a second, fl ash twice again, and then
remain steady. This sequence indicates that the accelerometers and the
Braking function are active again.
Actual Direction Control
When the “ICM” button on the upper left corner of the transmitter is pressed
for at least 3 seconds, the 1Si will enter the “Actual Direction Control” flight
mode and the LED on the back of quadcopter will flash slowly. In this mode,
the 1Si will use the pilot’s position as a reference point for any signal received
from the right stick on the transmitter. Moving stick forward or backward
will move the quadcopter farther or close to the pilot. The direction that the
front of the 1Si is facing will not have any effect while in this mode. The
antenna on the transmitter must be pointed at the quadcopter at all times
to help the model maintain its position while in flight.
To exit the “Actual Direction Control” mode, press the ICM button again for
3 seconds. The rear LED will become steady to indicate that it is now in the
normal flight mode.
Adjustment Mode
The 1Si will have to be put in the Adjustment
Mode before any adjustments to the return
speed or the sensors can be performed.
1. Turn on the transmitter and connect the
battery to the quad so it can link. Keep
the antenna pointed at the LED on the
1Si until the linking process is completed.
2. Press down on the right stick and hold
it down until the transmitter starts to beep. Continue to hold down the right
stick until the next step is completed.
3. Press down the left stick 4 times and then release both sticks. Push up on
the elevator trim button once and release it. At the same time, watch the display
for a change on the elevator trim indicator. If the indicator does not move, the
transmitter and 1Si are in the Adjustment Mode. Note: Pressing down on the
left stick at any time will cause the transmitter to exit the Adjustment Mode.
Auto Return
To make the 1Si return to you, press the ICM on the upper left corner of the
transmitter quickly and release it. The rear LED will flash quickly and model
will start to fly toward the transmitter. The pilot can use the throttle to control
the altitude, but any movement with the right stick will cause the model to
return to the normal flight mode. When the model gets close, the pilot should
expect to use the transmitter to slow the 1Si and bring it to a hover. Note:
The transmitter antenna should point at the quadcopter at all times to
help keep the 1Si on course.