Haltech F9A - Manual (Page 63)

62
Before loading a Datalog from disk, you should load the Maps that were saved with it so that
the programming software knows the setup of the ECU and can calibrate the data properly.
Do not load a Datalog when Online to the ECU, or else the Maps you load will overwrite
the Maps in the ECU. If you want to view a saved Datalog, switch to offline mode, load
the appropriate map, and then load the Datalog.
11.1.5 Printing Datalogs
You can print datalogs to any ASCII parallel printer, such as IBM compatible dot matrix
printers. This will print the current view only. If you wish to print another view, switch to
that view and print again. To print a datalog press
3
in the Datalog sub-menu.
The information in the datalog is divided into pages of data. The total number of pages in the
current datalog is displayed. The software will ask for the numbers of the first and last pages
you want to print. If you want to print the entire datalog , enter 1 for the first page, and the
number displayed as the last page.
The system pauses to allow you to set up the printer. If you do not want to print you can leave
the print function by pressing
}
. If you want to re-enter the start and end page numbers press
5
. Any other key begins the printing. Before you start printing the printer must be Online
and must have power and paper. Once the printing has started you can abort the printing at
any time by hitting
}
.