Great Planes Sportster Bipe 40 Kit - GPMA0510 - Manual (Page 17)

31. SAND THE TOPS OFTHE HOOD SIDE PIECES
top of the formers so the hood top will mate squarely.
Sand the tops of the hood side pieces flush with the
32. GLUE ON THE HOOD TOP; SAND HOOD SIDES
AT COCKPIT
Trim the hood top at the cabanes first before you
glue it on as it is a little difficult to sand in that area after the
hood top is glued on. Glue the hood top in place. Trim the hood
sides at the cockpit as shown on the plans.
33. ADDFORMER6A/6B
Pin the stabilizer in place so the stab is aligned with
the back of the fuselage. Mark the position of former 6A/6B.
Remove the stab. Glue 6A/6B in place.
34. GLUE ON TOP STRINGER
Use the 1/4 x 1/4 x 16 balsa stock and cut the top
stringer to fit between formers 3A/3B and 6A/6B. Glue the
stringer in place.
-17-