Golden Lighting 9903-BA3 - Manual

INSTALLATION INSTRUCTIONS
Fixture Name: AUTUMN TWILIGHT 9903-BA3
For Wall Mount Light Fixture
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
HANGING THE FIXTURE (Fig.1)
1. Carefully remove the new fixture from the carton
and the yellow parts bag. Check that all parts are
included as shown in the illustrations and Parts and
Assembly Sheet.
2. Shut off power at the circuit breaker and remove
the old fixture from wall, including the old
mounting strap.
3. Mounting Strap (A) contains several pairs of
threaded holes, Find the pair of holes that matches
the holes spacing in Back Plate (D) and thread the two
Mounting Screws (C) half way into Mounting Strap (A).
4. Place Mounting Strap (A) over the Junction
Box so that Mounting Screws (C) are vertical
or horizontal, as required by the fixture type.
5. Attach Mounting Strap (A) to the
Junction Box using the two Mounting Screws (B).
Tighten Mounting Screws (B) securely with a screwdriver.
CONNECTING THE WIRES（Fig.2）
6. Attach the power supply wires to the fixture lead
wires by connecting BLACK to BLACK (or SMOOTH)
and WHITE to WHITE (or RIBBED).
7. Attach the GROUND wire (GREEN or COPPER)
from the Junction Box and the fixture Ground wire
to the green Ground Screw on the Mounting
Bracket (B) or connect both wires together using
the correct size of wire connectors.
NOTE: Twist the wires together in the same direction
you twist the wire connector onto the wires.
8. Tuck these wire connections neatly into the
Junction Box.
FINISHING THE INSTALLATION（Fig.3）
9. After tucking the wire connections into
the Junction Box, place Back Plate
(D) over the two Mounting Screws (C) and secure
Back Plate (D) against the wall by threading
two Deco Nuts (E) over Mounting Screws
(C) until tight (as shown on Fig.3).
10. Install the crystals as per the Parts and Assembly
Sheet instructions.
YOUR INSTALLATION IS NOW COMPLETE. RETURN
POWER TO THE JUNCTION BOX AND TEST THE FIXTURE.
Fig. 1
JUNCTION BOX
D B A C
Fig.2
HOUSE WIRES
BLACK
(Hot)
FIXTURE WIRES
SMOOTH
(or Black)
RIBBED
(or White)
BARE COPPER
(or Green)
WHITE
(Neutral)
GREEN
(Ground)
Fig.3
E
JUNCTION BOX
C
D
F For Customer Service, contact the place of purchase to arrange for replacement parts.
C S A0 55 30 3V AL G 1