Golden Lighting 8995-M1L SBZ - Manual (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.
HANGING THE FIXTURE (Fig. 1)
1. Carefully remove the new fixture from the carton and
the yellow bag that holds all your parts. Check that all
parts are included as shown in the illustration and parts
list.
2. Shut off power at the circuit breaker and remove the
old fixture from ceiling, including the old mounting strap.
3. The Mounting bracket ( C ) contains several pairs of
threaded holes, find the pair of holes that match the
hole spacing in your fixture Back Plate (N) and thread
the two Mounting Screws (B) half way into the Mounting
Strap (C) facing down, these will have their threaded
ends protrude through the two holes in the fixture
canopy(N).
4. Place the Mounting Strap ( C ) over the junction box
5. Attach the Mounting Strap (C) to the Junction Box
using the two mounting screws (E). Tighten the screws
(E) securely with screw driver. Fig. 1
CONNECTING THE WIRES (Fig. 2)
6. Attach the power supply wires to the fixture lead
wires by connecting BLACK to BLACK (or SMOOTH)
and WHITE to WHITE (or RIBBED).
7. Attach the GROUND wire(GREEN or COPPER)
from the Junction Box and the fixture Ground wire to the
green Ground Screw on the Mounting Bracket (E) or
connect both wires together using the correct size of
wire connectors.
NOTE: Twist the wires together in the same direction
you twist the wire connector onto the wires.
8. Tuck these wire connections neatly into the Junction
Box. Fig. 2
For Mini Pendant Light Fixture
INSTALLATION INSTRUCTIONS
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
Fixture Name:
Woodbriar 8995-M1L SBZ
FINISHING THE INSALLATION (Fig. 3)
9. Place the fixture’s canopy over the Mounting bracket
(C), adjust the canopy (N) until the Mounting Screws (B)
protrude out from the canopy (N) and secure by
threading the Decorative nuts (O) on until tight.
10. Install the light bulbs and glass shade as per the
fixture assembly sheet.
YOUR INSTALLATION IS NOW COMPLETE.
RETURN POWER TO THE JUNCTION BOX AND
TEST THE FIXTURE. Fig. 3