Golden Lighting 8118-M3 PW - Manual (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.
PARTS & ASSEMBLY SHEET
Fig 2
Fixture Name: Alston Place 8118-M3 PW
ASSEMBLING THE FIXTURE (Fig.2)
4. By measuring determine correct number of links
needed for proper hanging height. Use a pair of pliers
to open one link of the Chain (C2) then remove the
excess Chain (C2) and discard it.
5. Use one chain connector (E2) to attach one end of
the chain to the Top loop (D2) and close the chain
connector.
6. Feed the fixture wires through the Chain (every
three links) and pull the wires until taut.
7. Slip Canopy loop collar (B2) over the chain, then do
the same with the canopy (F2).
8. When ready to complete the installation Use the
other chain connector and attach the other end of the
chain to the canopy loop (A2) and close the chain
connector.
9. Make sure the weight of the chandelier will be
supported by the chain-not the electrical wire.
* You may now install the fixture.
Note: Complete these remaining steps after the
fixture is hung.
10. Thread the Nipple (V) to connector (S),and slide
the Bottom cap (T), Crystal glass ball (U),Bottom cap
(W) on one by one, then use Finial (X) to thread tight.
11. Place the Glass Shades (O) over the Threaded
sockets (P),secure the Glass Shades (O) by threading
by the Socket Rings (N) until tight.
12. Install the light bulbs in accordance with the
fixture's specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING)