Golden Lighting 8118-M1L PW - Manual (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.
ASSEMBLING THE FIXTURE (Fig.2)
4. Pull the fixture’s wire through the Rods until taut.
5. Thread Rod (U) into Frame (P)until tight.
6. Thread Rod (M) into Rod (U) until tight. repeat for
any additional rods.
7. By measuring determine correct number of links
needed for proper hanging height. Use a pair of pliers
to open one link of the Chain (C2) then remove the
excess Chain (C2) and discard it.
8. Use one chain connector (E2) to attach one end of
the chain to the Top loop (D2) and close the chain
connector.
9. Feed the fixture wires through the Chain (every
three links) and pull the wires until taut.
10. Slip Canopy loop collar (B2) over the chain, then
do the same with the canopy (F2).
11. When ready to complete the installation Use the
other chain connector and attach the other end of the
chain to the canopy loop (A2) and close the chain
connector.
12. Make sure the weight of the fixture will be
supported by the chain-not the electrical wire.
* You may now install the fixture.
Note: Complete these remaining steps after the
fixture is hung.
13. Place the Glass Shade (O) over the Threaded
socket (P),secure the Glass Shade (O) by threading
by the Socket Ring (N) until tight.
12. Install the light bulb in accordance with the fixture's
specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING)
PARTS & ASSEMBLY SHEET
Fig 2
Fixture Name: Alston Place 8118-M1L PW