Golden Lighting 8106-FM CDB - Manual (Page 2)

For Flush Mount Light Fixture
INSTALLATION INSTRUCTIONS
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
Fixture Name: Torbellino 8106-FM CDB
Fig. 3
Fig. 1
Fig. 2
For Customer Service, contact the place of purchase to arrange for replacement parts.
HANGING THE FIXTURE
（Fig.1）
1. Carefully remove the new fixture from the carton
and the yellow bag that holds all parts. Check that
all parts are included as shown in the illustration
and parts list.
2. Shut off power at the circuit breaker and remove
old fixture from ceiling, including the old mounting
strap.
3. Thread the two Fixture Mounting Screws (A) into
the pre-drilled Hole in the Mounting Strap (B)
spaced the same distance apart as the hole in the
Ceiling Pan.
4. Attach Mounting Strap (B) to the junction box
using the two Screws (C).
CONNECTING THE WIRES (Fig 2)
5. Attach the power supply wires to the fixture lead
wires by connecting BLACK to BLACK (or
SMOOTH) and WHITE to WHITE (or RIBBED).
6. Attach the GROUND wire(GREEN or COPPER)
from the Junction Box and the fixture Ground wire to
the green Ground Screw on the Mounting Bracket
(B) or connect both wires together using the correct
size of wire connectors.
- NOTE:Twist the wires together in the same
direction you twist the wire connector onto the
wires.
7. Tuck these wire connections neatly into the
Junction Box.
FINISHING THE INSTALLATION (Fig.3)
8. Finish mounting the Ceiling Pan (D) by placing it
over the Mounting Strap (B) as shown on FIG.1.
Rotate the Pan until the Mounting screws (A)
protrude through the “Keyholes” located in the
bottom of Ceiling Pan (D). Using a screw driver,
secure the Ceiling Pan (D) by screwing Mounting
Screws (A) until taut.
9. Install the light bulbs in accordance to the fixture’s
specifications.
10. Install the glass shade as per the assembly
instructions.
YOUR INSTALLATION IS NOW COMPLETE. RETURN
POWER TO THE JUNCTION BOX AND TEST THE
FIXTURE.
D
F
G
E
H
J
L
K
M