Golden Lighting 8063-WSC BUS - Manual

Mounting strap 1ea
Mounting
screws
2ea
Fixture
mounting
screws
2ea
Hex nut 3ea
Wire
connectors
2ea Deco nut 2ea
Nipple
(Threaded rod)
1ea
Bottom
assembly
1ea
Flat washer 1ea
Rubber
washer
1ea Finial 1ea
Part Needed Quantity
Part Needed Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
F IXTURE A SSEMBLY I NSTRUCTIONS
For Customer Service, contact the place of purchase to arrange for replacement parts.
NOTE: I NSTALL THE GLASS ASSEMBLY
AFTER THE FIXTURE IS HUNG.
1. Place the Glass Shade(L) into the Fixture
Frame(M) with the notches in back of glass fitting
over the cross piece on back of frame.
2. Align the center hole of the Glass Shade (L) with
the hole in bottom of frame backplate (M).
3. Place the Rubber Washer(P) and the Flat
Washer(O) over the Nipple (Q) and secure with the
Hex Nut (N)approximatly 3/4" down the Nipple(Q).
4. Thread the Nipple(Q) through the bottom hole of
the Glass Shade(L) into the hole of Frame
backplate(M)and through the Hexnut attached
insde the backplate. Thread until snug to the glass.
5. Slide the Bottom Assembly (R) over the
Nipple(Q), screw the Finial(S) until tight.
6. Install the light bulb in accordance with the
fixture’s specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING!)
Fig 1
8063-WSC BUS
Read and review installation instruction sheet
before assembling the fixture.
PARTS & ASSEMBLY SHEET
This fixture assembled PO:__________ Date: ________
Fixture Name: Heartwood 8063-WSC BUS
Notice: Please review the parts listing and check for all parts before assembling the fixture. If any
parts are missing or damaged, please note onthis sheet and contact the place of purchase to
arrange for replacement parts.
PARTS LIST Company Name:_______________________Co. Account #:_________
to be filled out by retailer