Golden Lighting 8063-M1L BUS - Manual

Canopy 1ea Hex nut 2ea
Wire
connectors
2ea
Mounting
bracket
1ea Mounting screws 2ea Socket rings 1ea
Deco Nut 2ea
Fixture mounting
screws
2ea Socket washer 1ea
12" Rod 2ea 6" Rod
1ea
Part Needed Quantity
Part Needed Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
PARTS & ASSEMBLY SHEET
This fixture assembled PO:__________ Date: ________
Fixture Name: Heartwood 8063-M1L BUS
Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts
are missing or damaged, please note onthis sheet and contact the place of purchase to arrange for
replacement parts.
PARTS LIST
Company Name:_______________________Co. Account #:_____________
to be filled out by retailer
8063-M1L BUS
Read and review installation instruction sheet, but
do not install before assembling the fixture.
F IXTURE A SSEMBLY I NSTRUCTIONS
For Customer Service, contact the place of purchase to arrange for replacement parts.
NOTE: I NSTALL THE GLASS ASSEMBLY
AFTER THE FIXTURE IS HUNG.
1. By measuring determine correct number of rods
needed for proper hanging height. There are 2 optional
12" rods included.
2. To shorten the fixture trim the wires to the desired
length plus at least 8~10 inches.
2b. Slide the 6" rod plus the excess 12" rods off the wire.
2c. Thread the 6" rod back onto the wire then thread the
wire through the swivel conection into the canopy.
3. To lengthen the fixture pull all the wire out of the
canopy.
3b. Slide the 6" rod off the wire.
3c. Thread the additional rods with the 6" rod last back
onto the wire then thread the wire through the swivel
conection into the canopy. Fig 1
V
These two Rods may
be removed
or
additional Rods may
be added.
ROD-12 BUS