Golden Lighting 7644-SF GA - Manual (Page 3)

Fig. 2
INSTALLATION INSTRUCTIONS
Fixture Name: Mirabella 7644-SF GA
For Semi Flush / Convertible Light Fixture
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
HANGING THE FIXTURE as Semi flush (Fig. 1)
1. Carefully remove the new fixture from the carton and the yellow bag
that holds all your parts. Check that all parts are included as shown in
the illustration and parts list.
2. Shut off power at the circuit breaker and remove the old fixture from
ceiling, including the old mounting strap.
3. The Circular Strap (B) contains several pairs of threaded holes, find
the pair of holes that match the hole spacing in your fixture Canopy (F)
and thread the two Mounting Screws (A) half way into the Mounting
Strap (A) facing down, Secure in place with hex nuts. These will have
their threaded ends protrude through the two holes in the fixture
canopy(F).
4. Place the Mounting Strap (B) over the junction box.
5. Attach the Mounting Strap (B) to the Junction Box using the two
mounting screws (C). Tighten the screws (C) securely with screw
driver.
Fig. 1
CONNECTING THE WIRES (Fig. 2)
6. Attach the power supply wires to the fixture lead wires by connecting
BLACK to BLACK (or SMOOTH) and WHITE to WHITE (or RIBBED).
7. Attach the GROUND wire(GREEN or COPPER) from the Junction
Box and the fixture Ground wire to the green Ground Screw on the
Mounting Bracket (B) or connect both wires together using the correct
size of wire connectors.
NOTE: Twist the wires together in the same direction you twist the wire
connector onto the wires.
8. Tuck these wire connections neatly into the Junction Box.
FINISHING THE INSALLATION (Fig.3)
9. Place the fixture’s Canopy (F) over the Mounting Strap (B) and over
the Mounting Screws (A), adjust the fixture Canopy until the Mounting
Screws (A) protrude out from the canopy (D) and secure the fixture
against the ceiling by threading the decorative nuts on (E) until tight.
10. Install the light bulbs and glass shade as per the fixture assembly
sheet.
YOUR INSTALLATION IS NOW COMPLETE. RETURN POWER TO
THE JUNCTION BOX AND TEST THE FIXTURE.
Fig. 3
For Customer Service, contact the place of purchase to arrange for replacement parts.
BARE COPPER
(Ground)
GREEN
(Ground)
FIXTURE WIRES
SMOOTH (BLACK)
RIBBED (WHITE)
BLACK
WHITE
HOUSE WIRES
E
M