Golden Lighting 7116-BA2 LC - Manual (Page 2)

For Wall Mount Light Fixture
INSTALLATION INSTRUCTIONS
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
Fixture Name: Mayfair 7116-BA2 LC
For Customer Service, contact the place of purchase to arrange for replacement parts.
HANGING THE FIXTURE (Fig 1)
1. Carefully remove the new fixture from the carton and the
yellow bag that holes all your parts. Check that all parts are
included as shown in the illustration and parts list.
2. Shut off power at the circuit breaker and remove the old
fixture from wall, including the old mounting strap.
3. The Mounting Strap (F) contains several pairs of threaded
holes, find the pair of holes that match the holes spacing in
your fixture Back Plate (H) and thread the two Mounting
Screws (D) half way into the Mounting Strap (F) and secure
with Hex Nut (G).
4. Place the Mounting Strap (F)over the Junction Box (A)so the
Mounting Screws (D) are vertical or horizontal, as required by
fixture type.
5. Attach the Mounting Strap (F) to the Junction Box using the
two mounting screws (H)and tighten securely with screw driver.
CONNECTING THE WIRES (Fig 2)
6. Attach the power supply wires to the fixture lead wires by
connecting BLACK to BLACK (or SMOOTH) and WHITE to
WHITE (or RIBBED).
7. Attach the GROUND wire(GREEN or COPPER) from the
Junction Box and the fixture Ground wire to the green Ground
Screw (I) on the Mounting Bracket (F) or connect both wires
together using the correct size of wire connectors.
NOTE:Twist the wires together in the same direction you twist
the wire connector (L) onto the wires.
8. Tuck these wire connections neatly into the Junction Box.
FINISHING THE INSTALLATION (Fig 3)
9. After tucking these wire connections neatly into the Junction
Box, place the fixture Back Plate (H) over the two Mounting
Screws (B).
10. Secure the Back Plate (H) against the wall by threading two
Deco Nuts (P) over the two Mounting Screws (D) until tight as
shown on Fig.1.
11. Install the light bulbs and glass shade as per the fixture
assembly sheet.
YOUR INSTALLATION IS NOW COMPLETE. RETURN
POWER TO THE JUNCTION BOX AND TEST THE FIXTURE.
Fig. 3
Fig. 1
Fig. 2