Golden Lighting 6068-SF GMT - Manual (Page 2)

For Pendant Light Fixture
INSTALLATION INSTRUCTIONS
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
Fixture Name: Marco 6068-SF GMT
FINISHING THE INSALLATION (Fig. 3 )
9. Place the fixture’s canopy over the Mounting bracket
(C), adjust the canopy (N) until the Mounting Screws (B)
protrude out from the canopy (N) and secure by
threading the Decorative nuts (O) on until tight.
10. Install the light bulbs and glass shade as per the
fixture assembly sheet.
YOUR INSTALLATION IS NOW COMPLETE. RETURN
POWER TO THE JUNCTION BOX AND TEST THE
FIXTURE.
Fig. 3
For Customer Service, contact the place of purchase to arrange for replacement parts.
HANGING THE FIXTURE as Pendant (Fig. 1)
1. Carefully remove the new fixture from the carton and the
yellow bag that holds all your parts. Check that all parts are
included as shown in the illustration and parts list.
2. Shut off power at the circuit breaker and remove the old
fixture from ceiling, including the old mounting strap.
3. The Mounting bracket ( C ) contains several pairs of threaded
holes, find the pair of holes that match the hole spacing in your
fixture Back Plate (N) and thread the two Mounting Screws (B)
half way into the Mounting Strap (C) facing down, these will
have their threaded ends protrude through the two holes in the
fixture canopy(N).
4. Place the Mounting Strap ( C ) over the junction box
5. Attach the Mounting Strap (C) to the Junction Box using the
two mounting screws (E). Tighten the screws (E) securely with
screw driver.
Fig. 1
CONNECTING THE WIRES (Fig. 2)
6. Attach the power supply wires to the fixture lead wires
by connecting BLACK to BLACK (or SMOOTH) and
WHITE to WHITE (or RIBBED).
7. Attach the GROUND wire(GREEN or COPPER) from
the Junction Box and the fixture Ground wire to the green
Ground Screw on the Mounting Bracket (E) or connect
both wires together using the correct size of wire
connectors.
NOTE: Twist the wires together in the same direction you
twist the wire connector onto the wires.
8. Tuck these wire connections neatly into the Junction
Box.
Fig. 2