Golden Lighting 6068-M1L GMT - Manual (Page 2)

FINISHING THE INSALLATION (Fig. 3 )
9. Place the fixture’s canopy over the Mounting bracket
(C), adjust the canopy (N) until the Mounting Screws
(B) protrude out from the canopy (N) and secure by
threading the Decorative nuts (O) on until tight.
10. Install the light bulbs and glass shade as per the
fixture assembly sheet.
YOUR INSTALLATION IS NOW COMPLETE.
RETURN POWER TO THE JUNCTION BOX AND
TEST THE FIXTURE.
Fig. 3
For Customer Service, contact the place of purchase to arrange for replacement parts.
For Mini Pendant Light Fixture
INSTALLATION INSTRUCTIONS
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
HANGING THE FIXTURE as Pendant (Fig. 1)
1. Carefully remove the new fixture from the carton and the
yellow bag that holds all your parts. Check that all parts are
included as shown in the illustration and parts list.
2. Shut off power at the circuit breaker and remove the old
fixture from ceiling, including the old mounting strap.
3. The Mounting bracket ( C ) contains several pairs of
threaded holes, find the pair of holes that match the hole
spacing in your fixture Back Plate (N) and thread the two
Mounting Screws (B) half way into the Mounting Strap (C)
facing down, these will have their threaded ends protrude
through the two holes in the fixture canopy(N).
4. Place the Mounting Strap ( C ) over the junction box
5. Attach the Mounting Strap (C) to the Junction Box using
the two mounting screws (E). Tighten the screws (E) securely
with screw driver.
Fig. 1
Fixture Name: Marco 6068-M1L GMT
CONNECTING THE WIRES (Fig. 2)
6. Attach the power supply wires to the fixture lead
wires by connecting BLACK to BLACK (or SMOOTH)
and WHITE to WHITE (or RIBBED).
7. Attach the GROUND wire(GREEN or COPPER)
from the Junction Box and the fixture Ground wire to
the green Ground Screw on the Mounting Bracket (E)
or connect both wires together using the correct size of
wire connectors.
NOTE: Twist the wires together in the same direction
you twist the wire connector onto the wires.
8. Tuck these wire connections neatly into the Junction
Box.
Fig. 2