Golden Lighting 6068-8 GMT - Manual (Page 2)

6068 Series Instructions_20111103m.xls
Fig 4
For Customer Service, contact the place of purchase to arrange for replacement parts.
Fig 3
Fig 2 ASSEMBLING THE FIXTURE (Fig. 2)
3. Feed the fixture wires through the Top loop (J) and
pull the wires until taut.
4. Then screw the Top Loop (J) to the threaded center
column of Frame (M) until tight.
5. By measuring determine correct number of links
needed for proper hanging height. Use a pair of pliers
to open one link of the Chain (C2) then remove the
excess Chain (C2) and discard it.
6. Use one chain connector(E2) to attach one end of
the chain to the Top loop (D2) and close the chain
connector.
7. Feed the fixture wires through the Chain (every
three links) and pull the wires until taut.
8. Slip Canopy loop collar (B2) over the chain, then do
the same with the canopy (F2).
9. When ready to complete the installation Use the
other chain connector and attach the other end of the
chain to the canopy loop (A2) and close the chain
connector.
10. Make sure the weight of the chandelier will be
supported by the chain-not the electrical wire.
* You may now install the fixture.
Note: Complete these remaining steps after the fixture
is hung.
11. Install the light bulbs in accordance with the
fixture's
specifications.
12. Place the Glass shade (U) over the socket (V).
(DO NOT EXCEED MAXIMUM WATTAGE RATING)
PARTS & ASSEMBLY SHEET
Fixture Name: Marco 6068-8 GMT