Golden Lighting 3711-17 CB - Manual (Page 2)

INSTALLATION INSTRUCTIONS
Fixture Name: Rockefeller 2488-17 FI & 3711-17 CB
For Flush Mount Light Fixture
FINISHING THE INSTALLATION (Fig 3)
8. Finish mounting the Ceiling Pan (J) by placing it over the
Mounting Strap (E). Rotate the Pan until the Mounting
screws (G) protrude through the “Keyholes” located in the
bottom of Ceiling Pan (J). Using a screw driver, secure the
Ceiling Pan (J) by screwing Mounting Screws (G) until taut.
9. Install the light bulbs in accordance to the fixture’s
specifications.
10. Install the glass shade as per the assembly
instructions.
YOUR INSTALLATION IS NOW COMPLETE.
RETURN POWER TO THE JUNCTION BOX AND TEST
THE FIXTURE.
Fig. 3
For Customer Service, contact the place of purchase to arrange for replacement parts.
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
HANGING THE FIXTURE (Fig 1)
1.Carefully remove the new fixture from the carton and the
yellow bag that holes all your parts. Check that all parts are
included as shown in the illustration and parts list.
2. Shut off power at the circuit breaker and remove the old
fixture from ceiling, including the old mounting strap.
3. Thread the two Fixture Mounting Screws ( G ) into the
pre-drilled Holes in the Mounting Strap (E) spaced the
same distance apart as the holes in the Ceiling Pan.
Secure in place with Hex nuts (F).
4. Attach Mounting Strap ( E ) to the junction box using the
two Mounting Screws ( D )
Fig. 1
CONNECTING THE WIRES (Fig 2)
5. Attach the power supply wires to the fixture lead wires
by connecting BLACK to BLACK (or SMOOTH) and
WHITE to WHITE (or RIBBED).
6. Attach the GROUND wire(GREEN or COPPER) from
the Junction Box and the fixture Ground wire to the green
Ground Screw (L) on the Mounting Bracket (E) or connect
both wires together using the correct size of wire
connectors. NOTE: Twist the wires together in the same
direction you twist the wire connector onto the wires.
7. Tuck these wire connections neatly into the Junction
Box.
Fig. 2