Golden Lighting 3711-10 CB - Manual (Page 3)

WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
INSTALLATION INSTRUCTIONS
Fixture Name: Rockefeller 2488-10 FI & 3711-10 CB
For Chandelier Light Fixture
Fig. 1
6. Assemble the fixture and have an assistant or secure
support hold the weight of the fixture while you complete
the wiring connections.
7. Thread the fixture wires and ground wire of the
assembled fixture through the canopy loop and nipple
and into the outlet box.
For Customer Service, contact the place of purchase to arrange for replacement parts.
HANGING THE FIXTURE (Fig 1)
1. Carefully remove the new fixture from the carton and
the yellow bag that holds all parts. Check that all parts
are included as shown in the illustration and parts list.
2. Shut off the power at the circuit breaker and remove
old fixture from ceiling, including the old mounting strap.
3. Thread the Nipple(C) with Canopy Loop attached into
Mounting Strap (D).
4. Place Lock Washer (B) over end of Nipple (C)
protruding through Mounting Strap (D) and thread Hex
Nuts (A) onto Nipple until tight.
5. Take this mounting strap assembly and mount to
ceiling junction box with junction box Screws (E). Tighten
screw securely with screw driver.
CONNECTING THE WIRES (Fig 2)
8. Attach the power supply wires to the fixture lead wires
by connecting BLACK to BLACK (or SMOOTH) and
WHITE to WHITE (or RIBBED).
9. Attach the GROUND wire(GREEN or COPPER) from
the Junction Box and the fixture Ground wire to the green
Ground Screw on the Mounting Bracket (D) or connect
both wires together using the correct size of wire
connectors.
NOTE: Twist the wires together in the same direction you
twist the wire connector onto the wires.
10. Tuck these wire connections neatly into the Junction
Box. Fig. 2
FINISHING THE INSTALLATION
11. Place the fixture canopy (F), over the threaded rod
(C), so it protrudes through the hole in the Canopy (F).
Thread the Deco nut (I) onto the threaded rod and
continue turning until the Canopy (F) is snug against the
ceiling.
12. Install the light bulbs and glass shade as per the
fixture assembly sheet.
YOUR INSTALLATION IS NOW
COMPLETE. RETURN POWER TO THE
JUNCTION BOX AND TEST THE
FIXTURE.