Golden Lighting 3281-3P BI - Manual (Page 3)

For Chandelier Light Fixture
INSTALLATION INSTRUCTIONS
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
HANGING THE FIXTURE (Fig.1)
1. Carefully remove the new fixture from the carton and the
yellow bag that holds all parts. Check that all parts are
included as shown in the illustration and parts list.
2. Shut off the power at the circuit breaker and remove the
old fixture from ceiling, including the old mounting strap.
3. Thread Nipple (C) into Canopy Loop (F) until snug.
4. Thread the other end of Nipple (C) with the canopy loop
attached into Mounting Strap (D).
5. Place Lock Washer (B) over the end of Nipple (C) which
will protrude through Mounting Strap (D) and thread Hex Nuts
(A) onto the nipple until tight.
6. Take this mounting strap assembly and mount it to ceiling
junction box with Junction Box Screws (E). Tighten the
screws securely with screw driver.
Fixture Name: Moreno 3281-5/9/3P BI
Fig. 1
7. Unscrew Canopy Loop Collar (H ) from Canopy Loop (F).
Take the canopy and pass it over the canopy loop.
Approximately one half of the canopy loop exterior threads
should be exposed. Adjust until the desired height is reached.
The canopy loop collar should fit snugly on the canopy loop
after the canopy is installed. Remove the canopy and canopy
lock collar.
8. Assemble the fixture and have an assistant or secure
support hold the weight of the fixture while you complete the
wiring connections.
9.Thread the fixture wires and ground wire of the assembled
fixture through the canopy loop and nipple and into the outlet
box.
CONNECTING THE WIRES (Fig 2)
10. Attach the power supply wires to the fixture lead wires by
connecting BLACK to BLACK (or SMOOTH) and WHITE to
WHITE (or RIBBED).
11. Attach the GROUND wire (GREEN or COPPER) from
the Junction Box and the fixture Ground wire to the green
Ground Screw on Mounting Bracket (D) or connect both wires
together using the correct size of wire connectors.
NOTE: Twist the wires together in the same direction you
twist the wire connector onto the wires.
12. Tuck these wire connections neatly into the Junction Box.
Fig. 2
13. Raise Canopy (G) to the ceiling and secure in place by
tightening Canopy Loop Collar (H) into Canopy Loop (F)
14. Install the light bulbs as per the fixture assembly sheet.
YOUR INSTALLATION IS NOW COMPLETE.
RETURN POWER TO THE JUNCTION BOX AND
TEST THE FIXTURE.