Golden Lighting 3281-3P BI - Manual (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.
PARTS & ASSEMBLY SHEET
Fixture Name: Moreno 3281-3P BI
ASSEMBLING THE FIXTURE (Fig. 2)
3. Measure to determine the correct number of links
needed for proper hanging height. Use a pair of pliers
to open one link of the chain and remove and discard
any excess.
4. Use one Chain Connector (L) to attach one end of
the chain to the Top Loop (M) and close the chain
connector.
5. Feed the fixture wires through the Chain (every three
links) and pull the wires until taut.
6. Slip Canopy Loop Collar (H) over the chain, then do
the same with the Canopy (G).
7. When ready to complete the installation, use the
other chain connector and attach the other end of the
chain to the Canopy Loop (F) and close the chain
connector.
8. Make sure the weight of the chandelier will be
supported by the chain and not by the electrical wire.
* You may now install the fixture.
Note: Complete the remaining steps after the fixture is
hung.
9. Place the C andle Sleeve (P) over Socket (Q).
10. Install the light bulbs in accordance with the
fixture's
specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING)
Fig 2
Fig 4