Golden Lighting 3082-M1L PW - Manual (Page 2)

INSTALLATION INSTRUCTIONS
Fixture Name: Wynn 3082-M1L PW
For Pendant Light Fixture
For Customer Service, contact the place of purchase to arrange for replacement parts.
Fig. 2
Fig. 3
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
Fig. 1
HANGING THE FIXTURE (Fig. 1)
1. Carefully remove the new fixture from the carton and the
yellow bag that holds all your parts. Check that all parts are
included as shown in the illustration and on the Parts and
Assembly Sheet.
2. Shut off power at the circuit breaker and completely remove
the old fixture from wall, including the old mounting strap.
3. Mounting Strap (A) contains several pairs of threaded holes,
find the pair of holes that match the holes spacing in your fixture
Canopy (G) and thread the two Mounting Screws (B) into
Mounting Strap (A). Secure with Hex Nuts (C). The threaded
ends will protrude through the two holes in the fixture canopy.
4. Place Mounting Strap (A) over Junction Box (E) so that
Mounting Screws (B) are vertical or horizontal, as required by
fixture type.
5. Attach Mounting Strap (A) to Junction Box (E) by using the
two Mounting Screws (D). Tighten the screws securely.
CONNECTING THE WIRES (Fig. 2)
5. Attach the power supply wires to the fixture lead wires by
connecting BLACK to BLACK (or SMOOTH) and WHITE to
WHITE (or RIBBED).
6. Attach the GROUND wire (GREEN or COPPER) from the
Junction Box and the fixture ground wire to the green Ground
Screw on the Mounting Bracket (A) or connect both wires
together using the correct size of wire connectors.
NOTE: Twist the wires together in the same direction you twist
the wire connector onto the wires.
7. Tuck these wire connections neatly into the Junction Box.
FINISHING THE INSTALLATION (Fig. 3)
9. Place Fixture Canopy (G), over Mounting Screws (B), which
should protrude through the holes in the Canopy (G).
10. Thread Deco Nuts (F) onto the Mounting Screws (B) and
continue turning until the Canopy (G) is snug against the ceiling.
11. Install glass shades as per the fixture assembly instructions.
YOUR INSTALLATION IS NOW COMPLETE.
RETURN POWER TO THE JUNCTION BOX AND TEST THE
FIXTURE.
BARE COPPER
(Ground)
GREEN
(Ground)
FIXTURE WIRES
SMOOTH (BLACK)
RIBBED (WHITE)
BLACK
WHITE
HOUSE WIRES
C
B
G
A
F
OUTLET BOX
(CEILING)
C
B
G
A
F