Golden Lighting 3711-WSC CB - Manual (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.
HANGING THE FIXTURE (Fig. 1)
1. Carefully remove the new fixture from the carton and
the yellow bag that holes all your parts. Check that all
parts are included as shown in the illustration and parts
list.
2. Shut off power at the circuit breaker and remove the
old fixture from wall, including the old mounting strap.
3. Take Threaded Rod (D) from parts bag and thread
into center screw hole on Mounting Strap (A), tighten
with Hex Nut (B) and Spring Washer (C).
4. Attach the Mounting Strap (A) to the Junction Box (I)
using the two Mounting Screws (E). Tighten the screws
securely.
CONNECTING THE WIRES (Fig. 2)
5. Attach the power supply wires to the fixture lead wires
by connecting BLACK to BLACK (or SMOOTH) and
WHITE to WHITE (or RIBBED).
6. Attach the GROUND wire(GREEN or COPPER) from
the Junction Box and the fixture Ground wire to the
green Ground Screw on the Mounting Bracket (A) or
connect both wires together using the correct size of
wire connectors.
NOTE:Twist the wires together in the same direction you
twist the wire connector onto the wires.
7. Tuck these wire connections neatly into the Junction
Box.
FINISHING THE INSTALLATION (Fig. 3)
8. Place the fixture Back Plate (14) over the Threaded
Rod (D), so it protrudes through the hole in the Back
Plate (15).
9. Thread the Metal Cap Nut (6) onto the Threaded Rod
(D) and continue turning until the Back Plate (15) is snug
against the wall.
10. Install glass as per the fixture assembly instructions.
YOUR INSTALLATION IS NOW COMPLETE. RETURN
POWER TO THE JUNCTION BOX AND TEST THE
FIXTURE.
Fig. 3
Fig. 1
Fig. 2
For Wall Mount Light Fixture
INSTALLATION INSTRUCTIONS
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
Fixture Name: Rockefeller 2488-WSC FI &3711-WSC CB
GN D
A I C B
G F D E
JUNCTION BOX