Golden Lighting 1993-5 PS - Manual (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.
PARTS & ASSEMBLY SHEET
Fixture Name: Joia 1993-5 PS
Fig. 2
7. Slip Canopy loop collar (H) over the chain, then do the
same with the canopy (G).
8. When ready to complete the installation Use the other
chain connector and attach the other end of the chain to
the canopy loop (F) and close the chain connector.
9. Make sure the weight of the chandelier will be supported
by the chain-not the electrical wire.
* You may now install the fixture.
ASSEMBLING THE FIXTURE (Fig. 2)
3. By measuring determine correct number of
links needed for proper hanging height. Use a
pair of pliers to open one link of the Chain (K)
then remove the excess Chain (K) and discard it.
4. Use one chain connector (L) to attach one end
of the chain to the Top loop (J) and close the
chain connector.
5. Feed the fixture wires through the Chain (every
three links) and pull the wires until taut.
6. Slip Canopy loop collar (H) over the chain,
then do the same with the canopy (G).
7. When ready to complete the installation Use
the other chain connector and attach the other
end of the chain to the canopy loop (F) and close
the chain connector.
8. Make sure the weight of the chandelier will be
supported by the chain-not the electrical wire.
* You may now install the fixture.
Note: Complete these remaining steps after the
fixture is hung.
9. Install the light bulbs (not provided) in
accordance with the fixture's specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING)
C
D