Golden Lighting 1425-BA2 WG - Manual (Page 3)

Fig. 1
Fig. 2
5. Attach Mounting Strap (F) to the Junction Box using the two mounting
screws (H) and tighten securely with screw driver.
For Wall Mount Light Fixture
INSTALLATION INSTRUCTIONS
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
Fixture Name: Sancerre 1425-BA2 WG
For Customer Service, contact the place of purchase to arrange for replacement parts.
HANGING THE FIXTURE (Fig.1)
1. Carefully remove the new fixture from the carton and the yellow bag
that holds all your parts. Check that all parts are included as shown in the
illustrations and the Parts and Assembly Sheet.
2. Shut off power at the circuit breaker and remove the old fixture from
wall, including the old mounting strap.
3. Mounting Strap (F) contains several pairs of threaded holes. Find the
pair of holes that matches the holes spacing in your fixture Back Plate (H)
and thread the two Mounting Screws (D) half way into Mounting Strap (F)
and secure with Hex Nut (G).
4. Place Mounting Strap (F) over Junction Box (A) so that Mounting
Screws (D) are vertical or horizontal, as required by fixture type.
CONNECTING THE WIRES (Fig 2)
6. Attach the power supply wires to the fixture lead wires by connecting
BLACK to BLACK (or SMOOTH) and WHITE to WHITE (or RIBBED).
7. Attach the GROUND wire (GREEN or COPPER) from the Junction Box
and the fixture Ground wire to the green Ground Screw (I) on Mounting
Bracket (F) or connect both wires together using the correct size of wire
connectors. -
NOTE:Twist the wires together in the same direction you twist the wire
connector (L) onto the wires.
8. Tuck these wire connections neatly into the Junction Box.
FINISHING THE INSTALLATION(Fig.3)
9. After tucking these wire connections neatly into the Junction Box and
placing the fixture Back Plate (E) over the two Mounting Screws (D),
secure Back Plate (E) against the wall by threading two Deco Nuts (O)
over the two Mounting Screws (D) until tight as shown on Fig.1.
10. Install the light bulbs and glass shade as per the fixture assembly
sheet.
YOUR INSTALLATION IS NOW COMPLETE. RETURN POWER TO
THE JUNCTION BOX AND TEST THE FIXTURE.
Fig. 3