Golden Lighting 1425-BA2 WG - Manual

Part Needed Quantity
Part Needed Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
F IXTURE A SSEMBLY I NSTRUCTIONS
Read and review installation instruction sheet, but do not
install before assembling the fixture.
1425-BA2 WG
ASSEMBLING THE FIXTURE (Fig.1)
1. Crystal Chains (T) are individually wrapped and must
be hung piece by piece. Remove Crystal Chain (T) from
the packaging and examine the chain for Connection
Pin (U). Drape Crystal Chain (T) over Arm (S) so that
Connection Pin (U) sits on top of Arm (S). This will
ensure proper draping length.
2. Install outer, Clear Glass (S) and inner, Opal Glass
(R) by sliding both pieces of glass over Socket (T).
Place Gasket (Q) inside Opal Glass (R) and over Socket
(T). Secure glass in place by tightening Socket Ring (P)
over Socket (T), using Socket Tool (X).
Note: To avoid broken glass, do not over tighten Socket
Ring (P).
Fig 1
NOTE: I NSTALL THE GLASS ASSEMBLY AFTER
THE FIXTURE IS HUNG.
PARTS & ASSEMBLY SHEET
Fixture Name: Sancerre 1425-BA2 WG
This fixture assembled PO:__________ Date: ________
Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are
missing or damaged, please note onthis sheet and contact the place of purchase to arrange for
replacement parts.
PARTS LIST Company Name:_______________________Co. Account #:_____________
to be filled out by retailer
Mounting Strap Mounting Screws Deco Nut
1ea ∅4"*H2mm 2ea 8#32-IP*1" 2ea 8#32-IP*H9mm
Wire connectors Mounting Screws Hex Nut
3ea P3 Orange 2ea 8#32-IP*1-1/2" 2ea 8#32-IP*H3mm
Socket Tool
1ea 1-1/8"*3-5/8"