Golden Lighting 1260-3P RBZ User Manual

Page 2

1260Series instructions_20120731m.xls

For Customer Service, contact the place of purchase to arrange for replacement parts.

PARTS & ASSEMBLY SHEET

Fixture Name: Candace 1260-3P PW/RBZ

Fig 1

ASSEMBLING THE FIXTURE (Fig. 1)
1. This fixture is packed with the arms closed.
Gently spread the Arms (M) until evenly spaced.

2. Thread the Socket assembly (P) to Center
Column (N).

3. Pull the fixture wires through coupler(C),
Top Cap(K) and Top Loop (J) then screw
the Top Loop (J) to the coupler (C) until tight.

4. By measuring determine correct number of links
needed for proper hanging height. Use a pair of
pliers to open one link of the Chain then remove
the excess Chain and discard it.

5. Use one chain connector to attach one end of
the chain to the Top loop (J) and close the chain
connector.

6. Feed the fixture wires through the Chain (every
three links) and pull the wires until taut.

7. Slip Canopy loop collar over the chain, then do
the same with the canopy.

8. When ready to complete the installation Use the
other chain connector and attach the other end of
the chain to the canopy loop and close the chain
connector.

9. Make sure the weight of the chandelier is
supported by the chain-not the electrical wire.

*You may now hang the fixture

10. Screw the Threaded rod(Q) to coupler in
socket assembly, secure with hex nut.

11. Install the light bulbs in accordance with the
fixture's specifications.

12. Slide tthe Metal Sleeve (R) and the Cap (S)
onto rod (Q) and adjust the height, then
tighten with Hex Nut (W), slide Glass Shade (T),
Plastic Washer (U), Steel Washer (V) and tighten
with Hex Nut (W).

13. Place Bottom Cap onto the rod(Q) and thread
the Finial (Y) to the rod (Q) tightly.

DO NOT EXCEED MAXIMUM WATTAGE RATING!