Galaxy Audio AS-M700 - Manual (Page 3)

ANY SPOT
WIRELESS NOTE
1
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This
device may not cause harmful interference and (2) This device must accept any interference received, including
interference that may cause undesired operation.
Notice : The changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna
or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF
exposure requirements and void user's authority to operate the device.
1. Introduction
Thank you for purchasing our product. These wireless microphone systems operate on UHF band frequencies
with synthesizer control. Each system with 64 or 700 selectable frequencies, via Phase Locked Loop (PLL)
circuitry, makes it easy to choose non-interfering channels. (The number of available frequency channels
depends on local regulations.) Please read this instruction manual carefully before operating the system. This
manual covers the functions and operations of the wireless microphone systems.
2. Safety
Do not spill liquid on the appliance and do not drop it on a hard surface.
Do not place the appliance near heat sources such as radiators, amplifiers, etc. Do not expose it to direct
sunlight, extremely dusty conditions, excessive moisture, or vibration.
Remove the battery from the transmitter if the appliance will not be used for a long period of time. This will
avoid the damage resulting from a defective leaking battery.
3. Environment
Do not throw used batteries into a fire or garbage bin with domestic rubbish. Be sure to dispose of used
batteries in accordance with local waste disposal rules.
When disposing of the equipment, remove the batteries, separate the case, circuit boards, and cables, and
dispose of all components in accordance with local waste disposal rules.
4. Wireless Note
Before setting up make sure that the transmitter and receiver are tuned to the same frequency.
Do not use two transmitters on the same frequency.
Use good quality batteries to avoid the damage resulting from a defective leaking battery.
Turn the volume control on the receiver to adjust the receiver's output level to match the input level
requirements of the audio mixer, amplifier, or other device to which it is connected. (Refer to 7.2)
To avoid interference, do not operate the receiver near metal objects and maintain a line of sight between the
transmitter and receiver.
Avoid placing the receiver near TV’s, radios, computers, or other RF generating equipment such as CD players,
DAT machines, and digital processors that may be capable of producing interference.
Ш
Ш
Ш
Ш
Ш
Ш
Ш
Ш
Ш
Ш
Ш
WIRELESS MICROPHONE
UHF