Galaxy Audio AS-M700 - Manual (Page 14)

SETTING UP
MAX MIN
VOLUME
VOLUME
MIN MAX
ANY SPOT
7. Setting Up
NOTICE: Prior to setting up, check that the transmitter and receiver are tuned to the same frequency. Two or
more transmitters operating on the same frequency can not be used at the same time in the same
place, so please select different frequencies which can be used simultaneously in the same place.
7.1 Connecting the receiver to power
Plug the antennas into the TNC sockets on the receiver and point them upward.
Check that the voltage of the supplied AC adapter conforms to the voltage (AC110 or 220) available in the
local area. Using the wrong AC adapter may cause irreparable damage to the unit.
Plug the feeder cable of the supplied AC adapter into the DC IN socket on the receiver. Then plug the AC
adapter into a power outlet.
7.2 Connecting the receiver to an audio mixer or an amplifier
In order to ensure quality sound and avoid distortion, please adjust the volume level according to following
instructions.
Ш
Ш
Ш
Ш
Ш
Ш
AS-500R
When using a standard audio cable with 3-pin XLR connectors or ¼” (6.3mm) phone
plugs to plug into the MIC IN of an audio mixer or amplifier, please turn the Volume
Level Control on the receiver to the 1 o'clock position. The output level for balanced
and unbalanced outputs is about 77mV.
When using a standard audio cable with 3-pin XLR connectors or ¼” (6.3mm) phone
plugs to plug into the LINE IN of an audio mixer or amplifier, please turn the Volume
Level Control on the receiver to the MAX position. The output level for balanced and
unbalanced outputs is about 770mV.
Ш
Ш
Ш
AS-700R
When using a standard audio cable with 3-pin XLR connectors or ¼” (6.3mm) phone
plugs to plug into the MIC IN of an audio mixer or amplifier please push the Volume
Button on the receiver to a level of approximately 20. The output level for balanced and
unbalanced outputs is about 77mV.
When using a standard audio cable with 3-pin XLR connectors or ¼” (6.3mm) phone
plugs to plug into the LINE IN of an audio mixer or amplifier, please push the Volume
Button on the receiver to a level of approximately 32. The output level for balanced and
unbalanced output is about 770mV.
12
WIRELESS MICROPHONE
UHF
Never use the balanced and unbalanced audio outputs at the same time! This may cause
signal loss or increased noise.
Make sure that the MIC/LINE switch is in the correct position for the type of input to
which you are connecting.
Ш