Galaxy Audio LA4/LA4PM Yoke Bracket - Manual

GALAXY AUDIO LA4 YOKE BRACKET KIT
INSTRUCTIONS
Contents:
Yoke Bracket
Four ¼”-20 Screws
Four Rubber Washers
Four Flat Washers
Safety Cable
Safety Cable Clamp
Two Ferrules (cable crimps)
DESCRIPTION:
This Galaxy Audio Yoke Bracket is used for permanently mounting LA4
speaker cabinets to walls or ceilings. The mounting angle can be selected by
choosing the appropriate screw holes in the yoke. These brackets should be
used only on a secure and stable surface.
PRECAUTIONS:
Whenever an object is affixed to a wall or ceiling, you must take special care
to mount it securely to prevent it from falling and causing damage or injury.
MOUNTING SURFACES: Carefully examine the composition, construction
and strength of the surface you are mounting to. Be sure to provide adequate
reinforcement should you deem it necessary. You must also consider what
type of hardware and what types of mounting techniques are appropriate for
each mounting surface.
FASTENERS: Attaching the bracket requires fasteners selected for the
strength and composition of the mounting surfaces involved. Whatever
fastener is selected, it should be no smaller than a 1/4" screw or bolt. When
drilling pilot holes be sure that the holes are smaller than the core diameter
of the screw. Always use fasteners in all mounting holes and avoid over
tightening, as this can weaken the mounting surface, damage the fasteners,
and make the installation much less secure.
SECONDARY SUPPORT: As we recommend the use of a secondary
support for added safety, each yoke bracket is equipped with a safety cable.
When properly installed it provides secondary support without inhibiting the
adjustment of the bracket, and can be easily hidden out of sight.