Galaxy Audio TRAVELER AS-TV8 - Manual

MODULE INSTALLATION GUIDE
For
ANY SPOT TRAVELER AS-TV8
This guide provides installation instructions for the following Optional Function
Modules available for the Any Spot Traveler: AS-TVREC Wireless Mic/Audio Link
Receiver, AS-TVCD CD/MP3 Player, AS-TVTX Audio Link Transmitter, and AS-
TVEC Echo Module.
SAFETY NOTE: If you have any misgivings about your abilities to perform any of
these procedures, please allow Galaxy Audio or a qualified representative to do the work.
These procedures allow the user to install or remove any of these function modules
without disconnecting the internal batteries. However, please observe the following rules
when performing any operations listed in this guide:
1. Disconnect the AC power/charger cord from the Traveler and make sure the main
power switch and all module power switches are in the OFF position. This also
applies to any modules that you are preparing to install.
2. Remove any jewelry such as rings, bracelets, and wristwatches.
3. Once a panel or module is removed, do not probe inside the Traveler with any
metal object, such as a screwdriver. Even though the power switches are off, there
will still be voltage present at various places on the circuit boards, wires, and
connectors.
4. The plastic multi-pin connectors found on the wires are a locking type. Do not
pull on the wires to disconnect them. Rather, locate and disengage the release tabs
and pull gently on the plastic connector itself.
5. Each optional module must be installed only in the module bay designated for it.
Please see Photo 1, which shows locations where each module may be installed.
Photo 1.