Galaxy Audio DS-SP36 - Manual (Page 26)

25
Source page – from this page it is possible to assign one of the following Inputs to any Output Channel:
1. In A
2. In B
3. In C
4. In A and In B
5. In A and In C
6. In B and In C
The following is an example screen for the “Source” where Input A is assigned to Output Channel 1:
After pressing ENTER an arrow will appear on the left of the screen “ -> ” the Input can be selected by
rotating either the “PM2” or “PM3” encoders.
Gain page – from this screen it is possible to set the Output Channels Level from -12dB to +6dB, press
ENTER an arrow will appear on the left of the screen “ -> ” then use the “PM1” or “PM2” buttons.
The value set on this screen will only affect the input level of the selected Channel 1, 2, 3, 4, 5 or 6.
The following is an example screen for the “Gain” page where the Gain of the Output Channel 1 is set to
+0.0dB
Limiter sub-menu – from this page it is possible to set the Output Channels Limiter.
The following is an example screen for the Limiter page where the Attack Time of the Limiter is set at 5ms,
the Release Time is set at 0.2Sec and the Limiter Active Threshold is set at +5dB:
Upon pushing ENTER, the Limiter's parameters can be modified using the “NAV/PM1”, “PM2” and “PM3”
encoders for editing the Limiter's Attack Time [A], Release Time [R], and Active Threshold.
Upon pushing ENTER, the above screen will change as follows:
Out-1 Name Source
Source = InA
Out-1 Name Gain
–› Gain = + 0.0dB
Out-1 Name Limiter
A: 5ms R: 0.2s +5.0dB
Out-1 Name Limiter
–› A: 5ms R: 0.2s +5.0dB