Galaxy Audio DS-SP36 - Manual (Page 11)

10
– Save a Program: this page allows you to store a new preset in the DS-SP36’s memory:
By pressing the ENTER button and rotating the “PM2” or “PM3 encoder, it is possible to scroll through the
previously saved presets and the available empty locations (identified by “Empty Memory”).
If no user presets are stored, the “Save a Program” screen will show empty memory locations for all 1-24
presets as shown in the example below for location 10:
When storing an edited configuration for the DS-SP36, select the location for a preset from the 24 available
by using the “PM2” or “PM3” encoders.
Once the desired location appears on the screen press ENTER again to reach the “Set Program Name”
page.
In this page the User can enter a Preset Name ( up to 16 Characters ) by using the “PM2” or “PM3”
encoder to choose a character and the “NAV/PM1” encoder to move between the 16 available locations for
the character’s positioning.
The current position of the cursor is shown by a “blinking underscore”.
The following is an example of a screen while entering the preset name “Stage 1 2x2” in location 10:
To store the Preset Name press the “ENTER” button again.
The above action will take you to the “Enter to Save” page showing the selected location for
the preset and the final edited name:
Pressing “ENTER” again, will store the preset in the selected location with the chosen name and the
following transition screen will appear on the LCD:
PROGRAM UTILITY
– Save a Program –
Save a Program
10: Empty Memory
Set Program Name
10: Stage 1 2x2 ?
[Enter] to Save
10: Stage 1 2x2 ?
Saving to Memory
10: Stage 1 2x2